By NastyNils·
Motorcycle comparison · Supersport vs Naked Bike
Triumph Daytona 675 (D67LC) vs Street Triple 675 (MY2007)
Triumph Daytona 675 vs Street Triple 675: where they split, and which one to buy.
Deep into a tight bend, the Triumph Daytona 675 holds the exact line you've picked and doesn't make you fight for it. The Triumph Street Triple 675 tips in off the slightest nudge.
So which one do you buy?
Buy the Street Triple 675 if…
Daily commuting & city riding
Clear pick: Street Triple 675
When the bike has to work for a living, the Street Triple 675 wins the commute clearly.
The Daytona 675 has the edge if…
Sporty riding on twisty roads
By a nose: Daytona 675
Once the road starts to bend, the Daytona 675 noses ahead. Thank a sportier chassis and better suspension for that. Your own skill counts for more than a gap this size.
What makes each one tick
Daytona 675
Through a string of S-curves, the Daytona 675's slim frame and light tail flip from side to side without a struggle. Hours of hard laps don't wear down the bite at the brake lever, and the fork keeps its control to the end. On the Angeles Crest Highway, the triple doesn't protest at being left in second from the hairpins through the fast sweepers. Mid-corner ripples leave the chassis quiet.
Street Triple 675
Around a parking lot, the Street Triple 675 shuffles and turns at walking pace, and there's no heft to wrestle. The bike moves like it weighs nothing. In a switchback, corner entry doesn't need more than one push on the bar. It rotates through and exits clean. The triple's exhaust sends a shiver even at idle.
Nils rode the Street Triple 675 in 2007 and 2009 (NastyNils Testride).
The Voice of Experience
What actually separates them
- The Street Triple 675 has the lower seat: 31.5 in (800 mm) vs 32.5 in (825 mm).
- The Daytona 675 makes more peak power: 123 hp (92 kW) vs 106 hp (79 kW).
- The Daytona 675 makes more peak torque: 53 lb-ft (72 Nm) vs 50 lb-ft (68 Nm).
Which one for the way you ride
A confidence-building first motorcycle
Both miss here
A first bike should forgive mistakes, and these two don't do that well enough. Come back to them later.
Traveling with luggage
Neither is a natural fit
Both of these make awkward travel bikes. Pack light and keep the trips short.
Nothing splits them on running costs. Ride both back to back and the decision usually makes itself.
Who each one is built for
What's good, and what you'll live with
Daytona 675
Strengths
- Goes Exactly Where You Point
- Settled On Rough Corners
- Holds Up To Hard Use
- One Gear, Most Situations
- Characterful inline-triple engine
Trade-offs
- Throttle Lag Off A Closed Corner
- Rear Moves Under Hard Braking In Lean
- Track Tires Wear Fast
- Cramped, track-focused ergonomics
Street Triple 675
Strengths
- Torque That Arrives In Waves
- An Exotic For The Money
- Fit Tuned For Smaller Riders
- A Triple Voice With Real Character
- Light, precise handling
Trade-offs
- Wet-Weather Tire Risk
- Rear Linkage Bearings Seize
- Fuel Tank Coating Flakes
- Stock mirrors vibrate at highway speeds
- No ABS across entire generation
Known problems to check before you buy
Daytona 675
- Regulator/rectifier overheating and failure Recall 12V445000 The regulator/rectifier can overheat, preventing charging and causing the motorcycle to stall. An NHTSA recall (12V445000) was issued covering 2006–2009 Daytona 675 models.
- EXUP valve sticking The exhaust valve (EXUP) can seize or become noisy, triggering the check engine light and potentially affecting mid-range power. Often requires adjustment or replacement.
- Auto cam chain tensioner spring weakening The factory automatic cam chain tensioner uses a spring that weakens over time, allowing the cam chain to slacken. Symptoms include cold-start rattle progressing to rattle at idle and low RPM in all gears. In severe neglected cases, the chain can deposit aluminium filings in the cases or, in worst-case scenarios, fail catastrophically. The platform-shared issue is well documented across both the Street Triple 675 and its Daytona 675 sibling. Triumph subsequently moved to a hydraulic tensioner design on later platforms.
- Matt-finish engine case paint bubbling, peeling and corroding The matt powder-coated engine cases show bubbling, cracking and peeling due to inadequate factory surface preparation. Underlying corrosion forms, progressing if untreated. The issue is widely cited across both Street Triple 675 and Daytona 675 first-generation owner communities.
Street Triple 675
- Stator winding insulation breakdown The stator can fail through heat-driven breakdown of winding insulation. Failure often co-occurs with regulator/rectifier failure: an unregulated R/R can cook the stator through prolonged voltage abuse. Symptoms are loss of charging, occasionally accompanied by visibly burned windings or a melted connector between stator and R/R.
- Needle roller bearings in rear linkage seize from inadequate grease intervals The needle roller bearings in the rear suspension linkage corrode and seize because the factory-recommended grease interval (12,000 mi (20,000 km)) is too long for typical use, particularly in salt-belt regions where bearings can be destroyed before scheduled service. Multiple sources additionally report that the Base model's rear shock damping degrades noticeably between 10,000 and 20,000 mi.
- Auto cam chain tensioner spring weakening The factory automatic cam chain tensioner uses a spring that weakens over time, allowing the cam chain to slacken. Symptoms include cold-start rattle progressing to rattle at idle and low RPM in all gears. In severe neglected cases, the chain can deposit aluminium filings in the cases or, in worst-case scenarios, fail catastrophically. The platform-shared issue is well documented across both the Street Triple 675 and its Daytona 675 sibling. Triumph subsequently moved to a hydraulic tensioner design on later platforms.
- Closed-throttle to part-throttle stumble at low RPM A bog or stumble in the 4,000–6,000 rpm range when transitioning from closed throttle to small openings. Causes attributed across owner discussions include throttle position sensor calibration drift, idle stepper (ISCV) carbon buildup and throttle body fouling. The issue is commonly mitigated by ECU re-mapping (TuneECU community).
- Inner tank coating bubbling and flaking The internal coating of the fuel tank can bubble and flake, with fragments entering the fuel pump filter and lines. Symptoms include stumbling, stalling, hard starting and backfire. Triumph has acknowledged the issue under warranty in some markets.
- Two-piston Nissin sliding-pin front caliper seizure The Base model's front caliper sliders seize from corrosion, leading to uneven pad wear, spongy lever feel and accelerated disc wear. Particularly common in damp climates. The R variant uses different (Daytona-spec radial-mount four-piston) calipers and is not affected by this specific failure mode.
- Factory coolant hose clamps leak prematurely Several factory coolant hose clamps are reported as under-torqued or poorly positioned at assembly, with hose 22 (between engine and radiator, per Triumph parts diagrams) most commonly cited. Coolant weeping or dripping near the mid-engine is sometimes observed within the first 500–1,200 miles.
- Speedometer reads approximately 8% high The speedometer reads optimistically, showing a higher speed than the bike is actually traveling, and the gap widens as the indicated speed rises. The over-read stays on the legally permitted side, since a speedometer is not allowed to under-read. The odometer also runs slightly high, though by a smaller margin.
- Matt-finish engine case paint bubbling, peeling and corroding The matt powder-coated engine cases show bubbling, cracking and peeling due to inadequate factory surface preparation. Underlying corrosion forms, progressing if untreated. The issue is widely cited across both Street Triple 675 and Daytona 675 first-generation owner communities.
- Headlight lens cracking on the final-year angular units The plastic lenses of the angular twin headlights fitted to the final model year of this generation can crack without any impact damage, with fine cracks spreading across the lens over time. The earlier round headlights are not part of this pattern. Triumph answered with a dealer service bulletin rather than a safety recall, and owners report cracked units being replaced free of charge with a revised, tougher part.
What they share
- Displacement
- 675 cc
- Engine
- Inline-three
- Cooling
- Liquid-cooled
- Gearbox
- 6-speed
- Final drive
- Chain
- Fork
- Upside-down (USD)
- Front brake
- 308 mm
- Front tire
- 120/70-17
- Rear tire
- 180/55-17
Where the spec sheets split
| Daytona 675 | Street Triple 675 | |
|---|---|---|
| Seat height | 32.5 in (825 mm) | 31.5 in (800 mm) |
| Wet weight | 408 lb (185 kg) | 401 lb (182 kg) |
| Daytona 675 | Street Triple 675 | |
|---|---|---|
| Power | 123 hp (92 kW) | 106 hp (79 kW) |
| Peak power at | 12,600 rpm | 11,750 rpm |
| Torque | 53 lb-ft (72 Nm) | 50 lb-ft (68 Nm) |
| Peak torque at | 11,750 rpm | 9,100 rpm |
| Daytona 675 | Street Triple 675 | |
|---|---|---|
| Fuel capacity | 4.6 US gal (17.5 L) | 4.6 US gal (17.4 L) |
| Daytona 675 | Street Triple 675 | |
|---|---|---|
| Wheelbase | 54.9 in (1395 mm) | 55.5 in (1410 mm) |
What comes fitted, what costs extra
| Daytona 675 | Street Triple 675 | |
|---|---|---|
| Manually Adjustable Front Suspension | Standard | Not offered |
Head to head, area by area
Both bikes on the same scale, one area at a time.