By ·

Motorcycle comparison · Supersport

BMW S 1000 RR (K46) vs Aprilia RSV 4 Factory (MY2009)

BMW S 1000 RR vs Aprilia RSV 4 Factory: fast is a given. What sets them apart isn't.

On a wet, dusty road the BMW S 1000 RR's electronics catch each slip so quietly they're gone before you notice. The Aprilia RSV 4 Factory's Brembos stop it hard there.

BMW S 1000 RR (K46) and Aprilia RSV 4 Factory (MY2009) side by side
BMW S 1000 RR (K46) 2009–2018 · The Top-End That Won't Quit Aprilia RSV 4 Factory (MY2009) 2009–2013 · V4 Aggression, Fully Dialed

So which one do you buy?

The S 1000 RR has the edge if…

Keeping running costs low

Edges it: S 1000 RR

For the money you spend after the purchase, the S 1000 RR nudges ahead. The gap is too small to plan a budget around.

Daily commuting & city riding

Slight edge: S 1000 RR

The S 1000 RR edges it for the daily grind. It's a small gap, not a reason on its own.

Racetrack use

A touch ahead: S 1000 RR

On a circuit, the S 1000 RR feels a little sharper. The margin is thin, and setup can close it.

Which one's the smarter buy

No clear advantage

Neither bike is the clear better buy at these used prices. The S 1000 RR costs less, but that doesn't make it the smarter spend.

What makes each one tick

S 1000 RR

The S 1000 RR's inline-four saves its real shove for the top of the tach, where it's still pulling as the needle nears redline. Through the long sweepers at Barber Motorsports Park, the frame stays put while you hold the lean, and the front doesn't leave you guessing. Downshifts don't send a click back through the shift lever to confirm the gear. The gear always goes in.

Nils rode the S 1000 RR in Portugal in 2009, in Andalusia, Austria, Slovakia, and the Czech Republic in 2010, in Andalusia, Hungary, Slovakia, and the Eifel in 2011, in Andalusia and Spain in 2012, in 2014, in Andalusia in 2015, in Oman & UAE in 2016, and in Qatar in 2017 (NastyNils Testride).

RSV 4 Factory

The engine in the RSV 4 Factory doesn't really wake until high in the revs, then screams all the way to its redline. Pulling the brake lever hauls the bike down with huge stopping force, and there's room to trim it in tiny steps. The tires stay glued. Its exhaust answers in a deep, metallic howl.

Nils rode the RSV 4 Factory in 2009 and 2010 (NastyNils Testride).

The Voice of Experience

Portrait of NastyNils

What actually separates them

  • The S 1000 RR has the lower seat: 32.1 in (815 mm) vs 33.3 in (845 mm).
  • The S 1000 RR makes more peak power: 199 hp (146 kW) vs 180 hp (132 kW).
  • ABS: option on the S 1000 RR, not offered on the RSV 4 Factory.

See every difference ↓

Which one for the way you ride

A confidence-building first motorcycle

Not built for this

Neither of these is a sensible first motorcycle. Learn on something smaller and lighter, then come back.

Count twisty roads as a draw. The deal on the table and the condition of the bike matter more here.

Who each one is built for

US Trackday & Apex Hunter

Barber Motorsports Park · WeatherTech Raceway Laguna Seca · Circuit of The Americas

SoCal Canyon Performance Rider

Angeles Crest Highway · Coronado Trail Scenic Byway · Big Sur Coast Highway

Appalachian Technical Corner Rider

Back of the Dragon · Blue Ridge Parkway · Cherohala Skyway

What's good, and what you'll live with

S 1000 RR

Strengths

  • Top End Never Signs Off
  • Traction Control That Trims
  • Clutchless In Both Directions
  • Planted In Fast Sweepers
  • Class-leading peak power

Trade-offs

  • It Does Not Flick
  • Thin Below The Power Band
  • City Riding Is Work
  • Brake Lever Point Migrates
  • Snatchy throttle response (2010–2011)

RSV 4 Factory

What owners say

Strengths

  • Powerful Brembo braking performance

Known problems to check before you buy

S 1000 RR

  • Fuel pump flange may crack and leak fuel Recall 20V471000 The pneumatic fastening tool used at the fuel-pump supplier introduced stress at the pump flange during assembly. Over time, cracks can propagate at the flange and fuel can leak — fire risk in the presence of an ignition source. The recall covers MY2010–MY2011 S 1000 RR within a much larger 50,184-unit BMW two-wheel campaign that also covered other BMW Motorrad models. Remedy: dealer reinforces the flange with a support ring or replaces the fuel pump. A follow-up campaign (NHTSA 20V471) replaces fuel pumps that received only the support-ring repair under 13V617.
  • Sachs suspension underdamped for spirited / track use (especially 2010) The 2010 Sachs front fork is widely judged underdamped for spirited or track use; damping was improved in 2011 within the same generation. Cartridge re-valving is non-trivial because Sachs uses non-standard shim sizes — most track riders fit aftermarket cartridge kits. The Sachs rear shock is not user-rebuildable, and seal leaks have been reported.
  • Quickshifter intermittent or inoperative — wiring/connector at shift sensor Quickshifter stops working intermittently or completely. Documented root cause is most often the wiring or connector at the shift-sensor side rather than the sensor itself; BMW issued a service measure on the shift sensor. Some dealers misdiagnose and replace the sensor unnecessarily before fixing the wiring.
  • Balance-pipe / exhaust valve servomotor failure On MY2015–2016 K46 bikes (and some MY2017–2018), the balance-pipe valve servomotor bushing wears, the actuating cables can break, or the servo can seize in the activated position. Symptom: loud clicking on ignition, fault code, valve stuck open or closed. BMW has replaced full header systems under warranty in some documented cases. Aftermarket "servo eliminator" devices (HealTech, Servo Buddy) are common workarounds.
  • DDC dashboard error / calibration failure On MY2015–2018 K46 bikes optioned with DDC (Dynamic Damping Control), a "DDC!" dashboard warning or calibration failure can appear. Documented root causes include corroded or loose battery terminals, CAN-bus faults, and rear travel sensor displacement. Often resolves with re-calibration or wiring fix; in some cases the DDC shock has been replaced under warranty.
  • Brake judder / pulsing at the lever, mostly under track / hard road use Brake judder reported at the lever after hard use. Community consensus is that the cause is most often uneven pad-material deposit on the stock rotors (rather than true disc warpage), with stock pads judged inadequate for sustained track use. Common owner fix: switch to higher-spec pads (e.g., Brembo Z04) or upgraded discs.
  • Cam chain rattle at cold start (cam chain tensioner spring pressure) Loud cam chain rattle, particularly on cold start. BMW issued a service measure that replaces the original BLACK screw plug at the cam chain tensioner with a longer SILVER screw plug to increase tensioner spring pressure. The fix is applied only after approximately 9,300 mi (15,000 km) and only when the symptom is documented. Some owners switch to aftermarket manual cam chain tensioners (e.g., Alpha Racing) for track use. No engine failures attributed to the rattle in documented sources.
  • Vibration through tank, handlebars and pegs above 6,000 rpm Distinct vibration through tank, bars, footpegs and mirrors, intensifying past approximately 10,000 rpm. The K46 inline-four has no secondary balancer. Mirrors can blur at sustained high revs.
  • Aluminium frame transfers significant heat to rider's inner legs The aluminium twin-spar frame (used as a load-bearing element with the engine inclined into it) transfers significant engine and exhaust heat to the rider's inner legs, particularly in low-speed traffic and warm weather. Documented across all K46 model years. Common owner-installed mitigation: aftermarket carbon frame covers (e.g., Ilmberger).

RSV 4 Factory

  • Gearbox wear and failure Several owners report premature wear of 2nd and 6th gears, especially on track bikes or when using a quickshifter. The cassette-type gearbox must be opened for repair.
  • Cam chain tensioner rattle The hydraulic cam chain tensioner can stick and cause a loud rattling noise on cold starts. Later revisions of the part offer improved reliability.
  • Valve cover gasket leaks Oil weeping from the valve cover gaskets is a known issue, often requiring replacement at or before the valve clearance service.

What they cost used

These prices compare a 13-year-old S 1000 RR with a 13-year-old RSV 4 Factory.

S 1000 RR
about $11,300
RSV 4 Factory
about $12,600

At 13 years old, the BMW S 1000 RR sits around $11,300 while the Aprilia RSV 4 Factory runs about $12,600. That's a $1,300 gap in the BMW's favor. These are US market estimates, not live listings.

What they share

Displacement
999 cc
Cooling
Liquid-cooled
Gearbox
6-speed
Final drive
Chain
Front brake
320 mm

Where the spec sheets split

Seat height and weight
S 1000 RR RSV 4 Factory
Seat height 32.1 in (815 mm) 33.3 in (845 mm)
Wet weight 450 lb (204 kg) 448 lb (203 kg)
Engine, power and torque
S 1000 RR RSV 4 Factory
Engine Inline-four V4
Power 199 hp (146 kW) 180 hp (132 kW)
Peak power at 13,500 rpm 12,500 rpm
Torque 83 lb-ft (113 Nm) 85 lb-ft (115 Nm)
Peak torque at 10,500 rpm 10,000 rpm
Fuel economy and tank capacity
S 1000 RR RSV 4 Factory
Fuel economy 37 mpg (US) / 6.4 L/100 km 27 mpg (US) / 8.8 L/100 km
Fuel capacity 4.6 US gal (17.5 L) 4.5 US gal (17 L)
Other specifications
S 1000 RR RSV 4 Factory
Front tire 120/70 ZR17 120/70-17
Rear tire 190/55 ZR17 190/55-17
Wheelbase 56.1 in (1425 mm) 55.9 in (1420 mm)

What comes fitted, what costs extra

S 1000 RR RSV 4 Factory
ABS Option Not offered
Traction Control Standard Not offered
Wheelie Control Option Not offered
Launch Control Option Not offered
Quickshifter Option Not offered

Head to head, area by area

Both bikes on the same scale, one area at a time.

Braking

Engine

Handling

Suspension

Comfort

Reliability

Practicality

Sporting Capability

Usability

Specs and equipment as of November 6, 2026. The riding calls use the same ratings behind both buyer's guides.