By ·

Motorcycle comparison · Naked Bike

Yamaha MT-07 (RM04) vs Honda NC750S (RC 88)

Yamaha MT-07 vs Honda NC750S: which one to buy, and what actually separates them.

You'll find the Yamaha MT-07's front wheel climbing for a few yards the moment you crack the throttle off the line. On the Honda NC750S, that same roll-on finds a low-revving engine that's pulling from down low. It sips fuel even when you're wringing it.

Yamaha MT-07 (RM04) and Honda NC750S (RC 88) side by side
Yamaha MT-07 (RM04) 2014–2017 · Raw Twin, Weightless Handling Honda NC750S (RC 88) 2016–2020 · The Sensible Commuter Done Right

So which one do you buy?

The MT-07 has the edge if…

Sporty riding on twisty roads

Inches ahead: MT-07

Once the road starts to bend, the MT-07 noses ahead. The difference is harder acceleration and more feel through the bars. Your own skill counts for more than a gap this size.

Daily commuting & city riding

A touch ahead: MT-07

The MT-07 edges it for the daily grind. It's a small gap, not a reason on its own.

A confidence-building first motorcycle

Edges it: MT-07

Fresh off the training course, the MT-07 feels a bit more forgiving. Only by a small margin, though.

The NC750S has the edge if…

Traveling with luggage

Narrow edge: NC750S

Trips with luggage lean slightly toward the NC750S. The reason: more range per tank. Treat it as a tiebreaker.

What makes each one tick

MT-07

Nobody softened the MT-07 to keep it tame, and its crossplane twin thumps out a V-twin-like pulse with torque that's already strong low in the rev band. Corner entry doesn't take long: the bar answers each small nudge and the bike tips in at once. Its crossplane thump doesn't go stale.

NC750S

Right off idle, the NC750S's twin hauls hard, then it's done well before the tach reads high. A bump comes through harsh from the fork and rear shock. Brisk riding unsettles it. There's barely any weight in the clutch lever.

The Voice of Experience

Portrait of NastyNils

What actually separates them

  • The NC750S has the lower seat: 31.1 in (790 mm) vs 31.7 in (805 mm).
  • The MT-07 has the lower wet weight: 401 lb (182 kg) vs 478 lb (217 kg).
  • The MT-07 makes more peak power: 75 hp (55 kW) vs 55 hp (40 kW).

See every difference ↓

Which one for the way you ride

Comfortable long-distance riding

Both miss here

Both of these get tiring on a long day. A proper tourer will treat you better on big miles.

Who each one is built for

Appalachian Technical Corner Rider

SoCal Canyon Performance Rider

Bay Area Ridge Road Social Rider

What's good, and what you'll live with

MT-07

Strengths

  • Easy To Trust Quickly
  • Cheap To Run
  • Light, Friendly Controls
  • Addictive CP2 engine character
  • Accessible for all skill levels

Trade-offs

  • Idle And Decel Cutouts
  • Fragile 5th Gear
  • Quick To Corrode
  • Budget build quality
  • Jerky throttle response at low RPM

NC750S

What owners say

Strengths

  • Exceptional fuel efficiency
  • Legendary Honda reliability

Trade-offs

  • Uncomfortable stock seat
  • Lacks top-end excitement

Known problems to check before you buy

MT-07

  • Intermittent engine cutout at idle and during deceleration The engine cuts out intermittently, especially when idling at traffic lights or decelerating to a stop. The ECU appears to reduce fuel supply too aggressively at idle. Problem worsens in hot weather. Stalling during downshifting is particularly hazardous. Multiple NHTSA consumer complaints filed. Reportedly improved with ECU mapping adjustments in later production.
  • Battery loses charge during extended standstill Battery depletes when the bike sits for extended periods. Components draw power even when ignition is off. On models with parking light position, the ignition switch can cause parasitic draw if moisture enters. Some owners report charging system issues linked to the regulator/rectifier.
  • Instrument cluster LCD flickers, goes blank, or shows partial information LCD display develops flickering, blank sections, or complete failure. Causes include loose internal ribbon cable, water ingress, or corroded connector pins. Aftermarket replacement LCD modules available (same part 2014–2020 compatible).
  • Pronounced clutch rattle at idle; potential inner plate failure Pronounced rattling noise from the clutch at idle in neutral. Noise disappears when clutch lever is pulled in. In severe cases, inner clutch plates can break or shatter. Contributing factor may be worn clutch basket. More pronounced on cold starts.
  • Gear indicator fails to display correct gear (especially 5th/6th) The gear indicator in the LCD display fails to show the correct gear, particularly in 5th and 6th gear. The number flashes, disappears, or displays incorrect values. Root cause: dirty contacts on the gear position sensor. Cleaning is a temporary fix; sensor replacement (~40 USD) is the permanent solution. Yamaha developed a revised sensor.
  • Poor surface finishes on fasteners and coolant pipes Widespread corrosion across peripheral components: radiator coolant pipes (chrome with thin lacquer, deteriorates rapidly from road spray), allen key bolt heads, brake line fittings, disc bobbins, gear lever linkage, rear sprocket, suspension linkage fasteners, and seat lock (seizes). Screw heads across the frame show rust. Weld slag not properly cleaned on some frames.
  • Side stand safety switch causes unexpected engine cutout The bike starts normally in neutral but dies immediately when shifted into gear. Caused by the kickstand safety switch failing, corroding, or the starter cutoff relay malfunctioning. The switch connector is vulnerable to moisture ingress.
  • Surface rust on steel swingarm The steel swingarm develops surface rust, particularly underneath the chain guard and near chain adjusters. Rust can appear within months of purchase, even without winter riding. The paint/coating is thin and easily damaged by chain debris. Weld seams and areas under the chain slider are most affected. Yamaha has replaced some swingarms under warranty.

NC750S

  • Uncomfortable stock seat causes pain on long rides The forward-sloping seat design creates pressure points and discomfort after about an hour. Many owners resort to aftermarket seats, air cushions, or custom upholstery.
  • Corrosion on fasteners and small parts Bolts, brackets, and fasteners show surface rust prematurely, especially on bikes used year-round. Regular cleaning and application of protective spray helps, but it's a common cosmetic issue.

What they share

Engine
Parallel twin
Cooling
Liquid-cooled
Torque
50 lb-ft (68 Nm)
Fuel capacity
3.7 US gal (14 L)
Gearbox
6-speed
Final drive
Chain
Fork
Telescopic
Front tire
120/70-17

Where the spec sheets split

Seat height and weight
MT-07 NC750S
Seat height 31.7 in (805 mm) 31.1 in (790 mm)
Wet weight 401 lb (182 kg) 478 lb (217 kg)
Engine, power and torque
MT-07 NC750S
Displacement 689 cc 745 cc
Power 75 hp (55 kW) 55 hp (40 kW)
Peak power at 9,000 rpm 6,250 rpm
Peak torque at 6,500 rpm 4,750 rpm
Fuel economy and tank capacity
MT-07 NC750S
Fuel economy 53 mpg (US) / 4.4 L/100 km 67 mpg (US) / 3.5 L/100 km
Other specifications
MT-07 NC750S
Front brake 282 mm 320 mm
Rear tire 180/55-17 160/60-17
Wheelbase 55.1 in (1400 mm) 60.0 in (1525 mm)

What comes fitted, what costs extra

MT-07 NC750S
ABS Option Standard
LED Headlight Not offered Standard

Head to head, area by area

Both bikes on the same scale, one area at a time.

Braking

Engine

Handling

Suspension

Comfort

Reliability

Practicality

Sporting Capability

Usability

Specs and equipment as of November 6, 2026. The riding calls use the same ratings behind both buyer's guides.