By ·

Motorcycle comparison · Naked Bike vs Supermoto

Triumph Street Triple 675 (MY2007) vs Ducati Hypermotard 1100 (MY2007-S)

You'll crack the Triumph Street Triple 675's throttle and the bike that's been flicking around like a toy suddenly pulls with real muscle. Open up the Ducati Hypermotard 1100 and you'll feel its big twin thumping away underneath you. The buzz stays out of the bars and pegs.

Triumph Street Triple 675 (MY2007) and Ducati Hypermotard 1100 (MY2007-S) side by side
Triumph Street Triple 675 (MY2007) 2007–2012 · Triple Soul, Razor Handling Ducati Hypermotard 1100 (MY2007-S) 2008–2009 · Italian Thunder From The Bottom

So which one do you buy?

The Street Triple 675 has the edge if…

Daily commuting & city riding

Nose ahead: Street Triple 675

For the ride to work, the Street Triple 675 noses ahead. Don't let that alone make the call.

The Hypermotard 1100 has the edge if…

Sporty riding on twisty roads

Slight edge: Hypermotard 1100

On a winding road, the Hypermotard 1100 comes out a touch ahead. The reason: better suspension. You wouldn't bet much on a gap like that.

What makes each one tick

Street Triple 675

Direction changes come the instant you ask on the Street Triple 675, with the chassis swinging around its rider as if there's almost no weight there. One push on the bar's all a tight hairpin on the Angeles Crest Highway takes, and the bike holds its line to a clean exit. A mid-corner bump doesn't unsettle the chassis, because the suspension's set up for public roads instead of the track. The triple's exhaust sings from idle.

Nils rode the Street Triple 675 in 2007 and 2009 (NastyNils Testride).

Hypermotard 1100

You don't need special boots to shift the Hypermotard 1100 cleanly, since its clutch pull is light. Ducati reduced the spring force by adding clutch plates, and the difference is noticeable. Push into a long, fast corner and the quick-flick character stops working for you. Corner entry asks for the same work where the radius keeps tightening: one input on the handlebar won't carry it, and the bike needs steady pressure to keep adding lean. The engine's strong through the low and middle revs, then runs short of breath on long straights. The front wheel wants the sky.

The Voice of Experience

Portrait of NastyNils

What actually separates them

  • The Street Triple 675 has the lower seat: 31.5 in (800 mm) vs 33.3 in (845 mm).
  • The Street Triple 675 makes more peak power: 106 hp (79 kW) vs 92 hp (68 kW).
  • The Hypermotard 1100 makes more peak torque: 76 lb-ft (103 Nm) vs 50 lb-ft (68 Nm).

See every difference ↓

Which one for the way you ride

A confidence-building first motorcycle

Both miss here

If this is your first motorcycle, keep looking. Neither one makes learning easy.

Who each one is built for

SoCal Canyon Performance Rider

Angeles Crest Highway · Coronado Trail · Highway 1

Appalachian Technical Corner Rider

Back of the Dragon · Blue Ridge Parkway · Cherohala Skyway

Texas Hill Country Weekend Rider

Texas Hill Country · Twisted Sisters · Circuit of the Americas

What's good, and what you'll live with

Street Triple 675

Strengths

  • Torque That Arrives In Waves
  • An Exotic For The Money
  • Fit Tuned For Smaller Riders
  • A Triple Voice With Real Character
  • Light, precise handling

Trade-offs

  • Wet-Weather Tire Risk
  • Rear Linkage Bearings Seize
  • Fuel Tank Coating Flakes
  • Stock mirrors vibrate at highway speeds
  • No ABS across entire generation

Hypermotard 1100

From Nils' own saddle time

Strengths

  • Wheelies on tap
  • Design that stops traffic
  • Brakes bite hard, stay honest
  • Made for quick transitions
  • Buy the S, no question

Trade-offs

  • Top end runs dry
  • Zero storage, fixed seat
  • Wide mirrors fight city traffic
  • Long learning curve

Known problems to check before you buy

Street Triple 675

  • Stator winding insulation breakdown The stator can fail through heat-driven breakdown of winding insulation. Failure often co-occurs with regulator/rectifier failure: an unregulated R/R can cook the stator through prolonged voltage abuse. Symptoms are loss of charging, occasionally accompanied by visibly burned windings or a melted connector between stator and R/R.
  • Needle roller bearings in rear linkage seize from inadequate grease intervals The needle roller bearings in the rear suspension linkage corrode and seize because the factory-recommended grease interval (12,000 mi (20,000 km)) is too long for typical use, particularly in salt-belt regions where bearings can be destroyed before scheduled service. Multiple sources additionally report that the Base model's rear shock damping degrades noticeably between 10,000 and 20,000 mi.
  • Auto cam chain tensioner spring weakening The factory automatic cam chain tensioner uses a spring that weakens over time, allowing the cam chain to slacken. Symptoms include cold-start rattle progressing to rattle at idle and low RPM in all gears. In severe neglected cases, the chain can deposit aluminium filings in the cases or, in worst-case scenarios, fail catastrophically. The platform-shared issue is well documented across both the Street Triple 675 and its Daytona 675 sibling. Triumph subsequently moved to a hydraulic tensioner design on later platforms.
  • Closed-throttle to part-throttle stumble at low RPM A bog or stumble in the 4,000–6,000 rpm range when transitioning from closed throttle to small openings. Causes attributed across owner discussions include throttle position sensor calibration drift, idle stepper (ISCV) carbon buildup and throttle body fouling. The issue is commonly mitigated by ECU re-mapping (TuneECU community).
  • Inner tank coating bubbling and flaking The internal coating of the fuel tank can bubble and flake, with fragments entering the fuel pump filter and lines. Symptoms include stumbling, stalling, hard starting and backfire. Triumph has acknowledged the issue under warranty in some markets.
  • Two-piston Nissin sliding-pin front caliper seizure The Base model's front caliper sliders seize from corrosion, leading to uneven pad wear, spongy lever feel and accelerated disc wear. Particularly common in damp climates. The R variant uses different (Daytona-spec radial-mount four-piston) calipers and is not affected by this specific failure mode.
  • Factory coolant hose clamps leak prematurely Several factory coolant hose clamps are reported as under-torqued or poorly positioned at assembly, with hose 22 (between engine and radiator, per Triumph parts diagrams) most commonly cited. Coolant weeping or dripping near the mid-engine is sometimes observed within the first 500–1,200 miles.
  • Speedometer reads approximately 8% high The speedometer reads optimistically, showing a higher speed than the bike is actually traveling, and the gap widens as the indicated speed rises. The over-read stays on the legally permitted side, since a speedometer is not allowed to under-read. The odometer also runs slightly high, though by a smaller margin.
  • Matt-finish engine case paint bubbling, peeling and corroding The matt powder-coated engine cases show bubbling, cracking and peeling due to inadequate factory surface preparation. Underlying corrosion forms, progressing if untreated. The issue is widely cited across both Street Triple 675 and Daytona 675 first-generation owner communities.
  • Headlight lens cracking on the final-year angular units The plastic lenses of the angular twin headlights fitted to the final model year of this generation can crack without any impact damage, with fine cracks spreading across the lens over time. The earlier round headlights are not part of this pattern. Triumph answered with a dealer service bulletin rather than a safety recall, and owners report cracked units being replaced free of charge with a revised, tougher part.

Hypermotard 1100

  • Clutch wear and hydraulic issues (slip, drag, slave cylinder leak) Clutch plates can wear rapidly, causing slip under hard acceleration or drag when hot. Leaks from the clutch slave cylinder are also reported, leading to fluid loss and gear engagement problems.
  • Flaking paint on engine cases Exposure to road dirt and poor cleaning can cause the paint on the engine cases to bubble and flake, especially around the clutch slave cylinder area.

What they share

Gearbox
6-speed
Fork
Upside-down (USD)
Front tire
120/70-17
Rear tire
180/55-17

Where the spec sheets split

Seat height and weight
Street Triple 675 Hypermotard 1100
Seat height 31.5 in (800 mm) 33.3 in (845 mm)
Wet weight 401 lb (182 kg) 395 lb (179 kg)
Engine, power and torque
Street Triple 675 Hypermotard 1100
Displacement 675 cc 1078 cc
Engine Inline-three L-twin
Cooling Liquid-cooled Air-cooled
Power 106 hp (79 kW) 92 hp (68 kW)
Peak power at 11,750 rpm 7,750 rpm
Torque 50 lb-ft (68 Nm) 76 lb-ft (103 Nm)
Peak torque at 9,100 rpm 4,750 rpm
Top speed 143 mph (230 km/h) 123 mph (198 km/h)
Fuel economy and tank capacity
Street Triple 675 Hypermotard 1100
Fuel economy 46 mpg (US) / 5.1 L/100 km 32 mpg (US) / 7.4 L/100 km
Fuel capacity 4.6 US gal (17.4 L) 3.3 US gal (12.4 L)
Other specifications
Street Triple 675 Hypermotard 1100
Front brake 308 mm 305 mm
Wheelbase 55.5 in (1410 mm) 57.3 in (1455 mm)
Front travel 4.7 in (120 mm) 6.5 in (165 mm)
Rear travel 5.0 in (126 mm) 5.6 in (141 mm)

What comes fitted, what costs extra

Street Triple 675 Hypermotard 1100
Manually Adjustable Front Suspension Not offered Standard

Head to head, area by area

Both bikes on the same scale, one area at a time.

Braking

Engine

Handling

Suspension

Comfort

Reliability

Practicality

Sporting Capability

Usability

Specs and equipment as of October 23, 2026. The riding calls use the same ratings behind both buyer's guides.