By NastyNils·
Motorcycle comparison · Naked Bike vs Supersport
Ducati Monster 1200 (MY2014) vs SuperSport (MY2017)
Ducati Monster 1200 vs SuperSport: where they split, and which one to buy.
Grab the bars on the Ducati Monster 1200 and you're perched upright, weight pressed toward the front tire. On the Ducati SuperSport, raised clip-ons don't fold you nearly that far forward. You'll settle back into its plush seat.
So which one do you buy?
Buy the Monster 1200 if…
Daily commuting & city riding
Gets the nod: Monster 1200
The Monster 1200 suits a daily commute clearly better. In traffic, it's simply less work.
The Monster 1200 has the edge if…
Keeping running costs low
Narrow edge: Monster 1200
Day to day, the Monster 1200 works out slightly cheaper to own. The saving is small.
Which one's the smarter buy
Different classes, different trade-offs
The Monster 1200 and SuperSport sit in different classes, so value is a trade-off. Neither is the obvious better buy for the money.
What makes each one tick
Monster 1200
Out of a slow hairpin on the Angeles Crest Highway, the Monster 1200's big twin shoves hard before the revs even climb. A mid-corner bump doesn't upset the chassis, and the fork keeps reporting every shift in grip. You'll place it to the inch. The exhaust's bark stays raw at every speed.
SuperSport
Through a fast sweeper, the SuperSport's steel trellis frame stays planted and you'll lean it harder each time. A crack of the throttle brings the L-twin's pull in smoothly, and there's plenty through the middle revs. Momentum's what it rewards. The L-twin pulls cleanly from bend to bend.
The Voice of Experience
What actually separates them
- The Monster 1200 has the lower seat: 30.9 in (785 mm) vs 31.9 in (810 mm).
- The Monster 1200 makes more peak power: 135 hp (99 kW) vs 110 hp (81 kW).
- The Monster 1200 makes more peak torque: 87 lb-ft (118 Nm) vs 71 lb-ft (96 Nm).
Which one for the way you ride
Comfortable long-distance riding
Not built for this
Hours in the saddle won't flatter either of these. They're happier on shorter runs.
A confidence-building first motorcycle
Not their thing
Both of these ask too much of a rookie. Spend your first year on something lighter.
Nothing splits them on twisty roads. Ride both back to back and the decision usually makes itself.
Who each one is built for
What's good, and what you'll live with
Monster 1200
Strengths
- Brakes bite hard, easy to modulate
- Low-end shove beats the spec
- Front-end feedback, precise and constant
- At home in city traffic
- Confidence holds on wet roads
Trade-offs
- No storage, no weather cover
- Long wheelbase hates tight switchbacks
- Wind punishes taller riders
- Cluster looks good, reads poorly
- Abrupt fueling and throttle response (2014–2016)
SuperSport
What owners say
Strengths
- Broad, usable powerband
- Surprisingly comfortable sport-tourer ergonomics
Trade-offs
- Modest top-end power for experienced riders
Known problems to check before you buy
Monster 1200
- Rear brake performance loss — hose heat damage and air permeation Recall 21V315000 The rear brake hose layout near the exhaust manifold leads to heat damage and gradual air permeation into the rear hydraulic system, reducing rear brake effectiveness over time. Owners report the rear brake feels soft, requires bleeding repeatedly, and in some cases fails entirely. Two NHTSA recall campaigns (21V-315 and 21V-335) and the parallel Ducati internal campaigns CR215 / CR217 ultimately addressed the cause via reinforced replacement hoses. Pre-recall bikes that have not been to a dealer continue to exhibit the symptom.
- Jerky throttle, surge at low RPM (pre-facelift only) MY2014–2016 Monster 1200 and 1200 S exhibit jerky on/off throttle transitions and a stutter or surge at steady ~4,800 rpm. Some bikes are reported to enter limp mode after aggressive throttle action. Root causes flagged in community discussion include lean Euro 3 mapping, twist-grip electronics, and throttle-position-sensor (TPS) issues. Common fixes are an ECU flash, RapidBike EVO add-on module, dyno tune, or replacement of the throttle body assembly. The 2017 facelift's revised electronics, IMU, and updated mapping materially improved the issue; post-facelift bikes do not exhibit this behavior to the same degree.
- High-current stator-to-R/R connector burn-out The high-current connector between the stator and the regulator/rectifier is prone to corrosion, heat damage, and ultimately melt-down. Symptoms include voltage that fails to climb above approximately 12.6 V at 4,000 rpm, a visibly burned connector, and eventual battery or electronics damage. This is a documented Ducati family issue that pre-dates the Monster 1200 and is confirmed for it. The permanent fix is to solder the wires direct or replace with a marine-grade waterproof connector.
- Hydraulic clutch slave cylinder leak The stock hydraulic clutch slave cylinder leaks at the weep hole (DOT brake fluid) or through the pushrod O-rings (engine oil). The condition is widely reported across the Ducati hydraulic-clutch range and is confirmed for the Monster 1200. Workarounds include replacing the pushrod O-rings or upgrading to an aftermarket slave cylinder (e.g., Oberon).
- Internal rust formation in the fuel tank Multiple owners — including some on relatively new 1200 S bikes — report internal tank rust forming in patches around overflow and vent fittings. Suspected cause is dissimilar-metal corrosion accelerated by E10 fuel water separation when the bike is stored with low fuel. Ducati's response has been inconsistent across dealerships.
- Fuel pump harness break / fuel level sensor failure The fuel pump red wire breaks inside the harness potting; ethanol can corrode wire insulation and cause intermittent shorts; the fuel-level sensor fails. Symptom: the bike will not start after a ride (no pump prime), then starts again after 20–30 minutes of cool-down. Replacement harness is a low-cost Ducati part. The fuel-level sensor part was reportedly revised on the 2019 1200 S.
- Rear cylinder heat in stop-and-go traffic The Testastretta 11° rear cylinder is positioned directly under the rider's right thigh, and the rear exhaust header amplifies the heat. In stop-and-go traffic in warm weather, the heat is described as uncomfortable to painful. Once the bike is moving, the heat dissipates. This is a design-inherent characteristic of the rear-cylinder-forward L-twin layout, not a defect. Owner workarounds include ceramic-coated headers, heat shields, and protective riding gear.
- Oil pressure sensor seal leak The oil pressure sensor switch develops a weep at the seal between the metal body and the plastic switch portion. The drip leaves engine oil on the engine cases. This is a common Ducati family issue, confirmed for the Monster 1200. The fix is inexpensive (sensor or O-ring replacement).
- Rough running and stalling at low ambient temperatures The bike starts rough, RPM hunts, and the engine stalls when ambient temperature is below approximately 64 °F (18 °C). Causes flagged in community discussion include tight exhaust valve clearances, EVAP canister blockage, and ECU mapping. A common workaround is leaving the ignition on for 30 seconds before cranking to allow the fuel pump to prime and sensors to initialize. The issue is typically resolved after the next valve adjustment service.
- Shared rider/pillion peg bracket — cramped layout (pre-facelift) Pre-2017 Monster 1200 / 1200 S uses a shared rider/pillion peg bracket and a tight pillion seat. Reports describe a cramped pillion experience and limited rider footroom (riders often "on toes" rather than flat on the pegs). Ducati addressed this with the 2017 facelift, which introduced separate rider and pillion peg brackets.
- Side stand interlock switch contamination and failure The side stand cut-out switch becomes contaminated with chain lubricant and grit and fails. The failure mode is either preventing the bike from starting, or failing to cut the engine when the stand is down with the bike in gear (loss of safety interlock). This is a long-standing Ducati family issue dating back roughly two decades and is confirmed for the Monster 1200.
SuperSport
- Rear brake hose air ingress (recall) Recall 21V315000 Potential for air to enter the rear brake system, reducing braking effectiveness. Affects all 2017-2020 SuperSport models. Ducati issued recall SRV-RCL-21-006 (NHTSA 21V315) to replace rear brake hoses.
- Gear lever interference recall (2018 base model) Recall 18V835000 In 2018, base SuperSport models were recalled for interference between the gear lever and pivot pin, which could affect gear changes.
What they cost used
Both bikes priced used at the same age: 6 years old.
- Monster 1200
- $11,000
- SuperSport
- $10,000
At six years old, the Ducati Monster 1200 sits around $11,000 while the Ducati SuperSport lands near $10,000. That's a $1,000 gap in the SuperSport's favor. These figures come from earlier US market records, not live listings.
What they share
- Cooling
- Liquid-cooled
- Gearbox
- 6-speed
- Final drive
- Chain
- Front tire
- 120/70-17
Where the spec sheets split
| Monster 1200 | SuperSport | |
|---|---|---|
| Seat height | 30.9 in (785 mm) | 31.9 in (810 mm) |
| Wet weight | 461 lb (209 kg) | 463 lb (210 kg) |
| Monster 1200 | SuperSport | |
|---|---|---|
| Displacement | 1198 cc | 937 cc |
| Engine | 90° V-twin | L-twin |
| Power | 135 hp (99 kW) | 110 hp (81 kW) |
| Peak power at | 8,750 rpm | 9,000 rpm |
| Torque | 87 lb-ft (118 Nm) | 71 lb-ft (96 Nm) |
| Peak torque at | 7,250 rpm | 6,500 rpm |
| Monster 1200 | SuperSport | |
|---|---|---|
| Fuel capacity | 4.6 US gal (17.5 L) | 4.2 US gal (16 L) |
| Monster 1200 | SuperSport | |
|---|---|---|
| Rear tire | 190/55-17 | 180/55-17 |
| Wheelbase | 59.5 in (1511 mm) | 58.2 in (1478 mm) |
What comes fitted, what costs extra
| Monster 1200 | SuperSport | |
|---|---|---|
| Steering Damper | Standard | Option |
| Quickshifter | Option (from 2017) | Option |
| TFT Display | Standard | Not offered |
| Smartphone Connectivity | Not offered | Option |
Head to head, area by area
Both bikes on the same scale, one area at a time.