By NastyNils·
Motorcycle comparison · Supersport
Aprilia RSV 1000 R Factory (RSV Mille R Factory) (MY2005) vs RSV 4 Factory (MY2009)
Brake late for a fast bend on the Aprilia RSV 1000 R Factory (RSV Mille R Factory), and it doesn't pile weight onto your wrists as it tips in. The Aprilia RSV 4 Factory's radial Brembo calipers clamp the discs with real force. Its bite builds in fine steps that don't snatch.
So which one do you buy?
The RSV 4 Factory has the edge if…
Racetrack use
Small edge: RSV 4 Factory
Track days lean slightly toward the RSV 4 Factory. It's down to stronger brakes. Count it as a small bonus.
Sporty riding on twisty roads
A touch ahead: RSV 4 Factory
On a twisty road, the RSV 4 Factory edges ahead. Not by enough to settle it alone.
What makes each one tick
RSV 1000 R Factory (RSV Mille R Factory)
Off the bottom of the revs, there's real shove from the RSV Mille R Factory's V-twin, which keeps thumping hard through the midrange. Each small twist of the throttle gets an even answer, and it's the same wherever the needle sits. There's no adjustment period with the seat and tank: the geometry does the work. The exhaust's bark comes through unfiltered.
Nils rode the RSV 1000 R Factory (RSV Mille R Factory) in Italy in 2006 (NastyNils Testride).
RSV 4 Factory
The RSV 4 Factory's powerband explodes high in the rev range, and there's a deep metallic howl from the exhaust. The lever hauls it down hard. There's plenty of room to modulate each extra squeeze.
Nils rode the RSV 4 Factory in 2009 and 2010 (NastyNils Testride).
The Voice of Experience
What actually separates them
- The RSV 1000 R Factory (RSV Mille R Factory) has the lower seat: 31.9 in (810 mm) vs 33.3 in (845 mm).
- The RSV 4 Factory makes more peak power: 180 hp (132 kW) vs 143 hp (105 kW).
- The RSV 4 Factory makes more peak torque: 85 lb-ft (115 Nm) vs 79 lb-ft (107 Nm).
Which one for the way you ride
Comfortable long-distance riding
Both fall short
Long days aren't what these two do best. Plan shorter legs and plenty of stops.
Count commuting and running costs as a draw. The deal on the table and the condition of the bike matter more here.
Who each one is built for
What's good, and what you'll live with
RSV 1000 R Factory (RSV Mille R Factory)
Strengths
- Geometry That Fits Instantly
- Strong, Honest Low-End Pull
- Forgiving Corner Exits
- Öhlins Feedback And Lean Room
- Characterful V-twin engine
Trade-offs
- Sharp Engine Braking
- Charging System Weak Point
- Electrical and charging gremlins
- Uncompromising riding position
- Sparse dealer network
RSV 4 Factory
What owners say
Strengths
- Powerful Brembo braking performance
Known problems to check before you buy
RSV 1000 R Factory (RSV Mille R Factory)
- Fuel hose recall (2005-2007) Recall 08V306000 NHTSA recall 08V306: fuel pump/filter hose may leak, posing fire risk. Affected bikes should have been fixed by dealers.
- Suspension linkage plate fracture The stock suspension linkage plates have been known to crack or snap without warning, causing collapse of the rear suspension.
- Stator and brown connector failure The permanent-magnet rotor is too strong, causing stator overheating, burning of the brown connector between stator and regulator, and ultimately charging system failure. Upgraded rotor and connector fixes are available.
- Sprag clutch failure If the battery is weak and the engine kicks back during starting, the sprag clutch can shatter, requiring an expensive crankcase split to repair. Keeping the battery fully charged mitigates the risk.
- Rear brake inefficiency The rear brake is notoriously weak and difficult to bleed properly, often requiring regular maintenance to retain any feel.
- Clutch slave cylinder seal leakage The standard clutch slave cylinder can weep fluid; an aftermarket unit (e.g. Oberon) cures the problem. Early symptom is fluid loss and spongy clutch.
- Difficulty finding neutral Gearbox can be stubborn finding neutral when stationary; clutch drag often plays a role.
- Odometer reset problem (2004‑2005 models) On earlier second‑generation RSVs, the odometer can spontaneously reset to zero or reset when the battery is disconnected. Later production (post‑2005) received an updated instrument panel that eliminated this fault.
RSV 4 Factory
- Gearbox wear and failure Several owners report premature wear of 2nd and 6th gears, especially on track bikes or when using a quickshifter. The cassette-type gearbox must be opened for repair.
- Cam chain tensioner rattle The hydraulic cam chain tensioner can stick and cause a loud rattling noise on cold starts. Later revisions of the part offer improved reliability.
- Valve cover gasket leaks Oil weeping from the valve cover gaskets is a known issue, often requiring replacement at or before the valve clearance service.
What they share
- Cooling
- Liquid-cooled
- Gearbox
- 6-speed
- Final drive
- Chain
- Fork
- Upside-down (USD)
- Front brake
- 320 mm
- Front tire
- 120/70-17
Where the spec sheets split
| RSV 1000 R Factory (RSV Mille R Factory) | RSV 4 Factory | |
|---|---|---|
| Seat height | 31.9 in (810 mm) | 33.3 in (845 mm) |
| RSV 1000 R Factory (RSV Mille R Factory) | RSV 4 Factory | |
|---|---|---|
| Displacement | 998 cc | 999 cc |
| Engine | 60° V-twin | V4 |
| Power | 143 hp (105 kW) | 180 hp (132 kW) |
| Peak power at | 9,500 rpm | 12,500 rpm |
| Torque | 79 lb-ft (107 Nm) | 85 lb-ft (115 Nm) |
| Peak torque at | 7,500 rpm | 10,000 rpm |
| RSV 1000 R Factory (RSV Mille R Factory) | RSV 4 Factory | |
|---|---|---|
| Fuel economy | 30 mpg (US) / 7.85 L/100 km | 27 mpg (US) / 8.8 L/100 km |
| Fuel capacity | 4.8 US gal (18 L) | 4.5 US gal (17 L) |
| RSV 1000 R Factory (RSV Mille R Factory) | RSV 4 Factory | |
|---|---|---|
| Rear tire | 190/50-17 | 190/55-17 |
What comes fitted, what costs extra
| RSV 1000 R Factory (RSV Mille R Factory) | RSV 4 Factory | |
|---|---|---|
| Ride Modes | Not offered | Standard |
Head to head, area by area
Both bikes on the same scale, one area at a time.