By NastyNils·
Motorcycle comparison · Naked Bike
Triumph Speed Triple 1050 (MY2011) vs Moto Guzzi Griso 1200 8V (MY2010)
Hauling down from speed, the Triumph Speed Triple 1050's brakes bite at true sportbike level, and the lever doesn't go vague in your hand. Squeeze the Moto Guzzi Griso 1200 8V's lever and it's Brembo radial calipers taking the load. The Guzzi stays planted while it sheds speed.
So which one do you buy?
The Speed Triple 1050 has the edge if…
Sporty riding on twisty roads
Small edge: Speed Triple 1050
On a winding road, the Speed Triple 1050 comes out a touch ahead. Credit a sportier chassis and lighter steering. You wouldn't bet much on a gap like that.
The Griso 1200 8V has the edge if…
Keeping running costs low
Nose ahead: Griso 1200 8V
For the money you spend after the purchase, the Griso 1200 8V nudges ahead. The gap is too small to plan a budget around.
Which one's the smarter buy
No clear winner on value
The Griso 1200 8V costs less, but that doesn't make it the better buy. Neither bike is the clear winner on value alone. Your choice depends on what you want the bike to do.
What makes each one tick
Speed Triple 1050
The Speed Triple's long-stroke triple doesn't need revs to get going: its fat torque shoves the bike forward from low down. Each roll of the throttle brings an intake growl that no twin or four can copy. It doesn't flop into a turn or stand back up once the bars tip it over. The bike flicks edge to edge.
Nils rode the Speed Triple 1050 in 2013 (NastyNils Testride).
Griso 1200 8V
There's a deep exhaust thump from the Griso's transverse V-twin, and it pulls strong as the revs build. Through the bends of the Blue Ridge Parkway, the 60.8 in (1544 mm) wheelbase and shaft drive hold the Griso steady as it turns in. The suspension doesn't fidget as the pace picks up. The long chassis holds its line.
The Voice of Experience
What actually separates them
- The Griso 1200 8V has the lower seat: 31.5 in (800 mm) vs 32.5 in (825 mm).
- The Speed Triple 1050 has the lower wet weight: 467 lb (212 kg) vs 500 lb (227 kg).
- The Speed Triple 1050 makes more peak power: 136 hp (102 kW) vs 110 hp (81 kW).
Which one for the way you ride
Comfortable long-distance riding
Wrong job for both
Long days aren't what these two do best. Plan shorter legs and plenty of stops.
A confidence-building first motorcycle
Neither is a natural fit
A first bike should forgive mistakes, and these two don't do that well enough. Come back to them later.
Nothing splits them on commuting. Ride both back to back and the decision usually makes itself.
Who each one is built for
What's good, and what you'll live with
Speed Triple 1050
Strengths
- Good chassis feedback
- Handy and neutral falling into a lean
- Sport-level brakes you can trust
- Distinctive triple character
- 2016 update closed the electronics gap
Trade-offs
- Charging system reliability concerns
- Limited wind protection
Griso 1200 8V
What owners say
Strengths
- Torquey, character-laden V-twin
- High-quality cycle parts
- Striking Italian styling and finish
Trade-offs
- Clunky, slow-shifting gearbox
- Overweight and lacks outright top-end power
Known problems to check before you buy
Speed Triple 1050
- Generator link lead wire chafe — engine stall risk On ABS-equipped bikes, the generator link lead in the charging circuit can rub against the ABS modulator mounting bracket. Over time, vibration wears through the wire insulation. This can cause an electrical short and an unexpected engine stall.
- Neutral indicator switch incorrect washer thickness Recall 13V211000 A washer of incorrect thickness between the neutral indicator switch and the gear selector drum can cause the neutral indicator to falsely show the bike is in neutral when it is not. Releasing the clutch in this condition can cause unexpected lurching and crash risk. **Official safety recall.**
- 2011-only front brake rotor warping 2011 examples specifically reported warped front rotors (Sunstar disc supplier issue cited as a wider-industry pattern in 2011). Some replacement floating discs from grey-market sources reportedly assembled incorrectly. Triumph subsequently moved to Brembo monobloc on R variants from 2012 and revised the brake package for 2016.
- ABS warning light triggered by sensor air-gap or connector corrosion ABS warning light triggered by sensor air-gap out of specification, connector corrosion, or failed sensor. Speedometer can freeze when the rear ABS sensor fails because the speed signal on these bikes is derived from the rear-wheel ABS sensor.
- Rear wheel hub bearing premature wear The single-sided swingarm rear hub uses needle bearings that can fail before sealed bearings would in a conventional dual-sided design. Wide range of reported failure mileages (15,000–56,000 miles); inadequate factory grease and bearing quality cited by long-term owners.
- Charging system: regulator/rectifier failure leading to stator failure The factory shunt-type regulator/rectifier runs very hot because it dumps surplus charging current as heat. Over time it can fail, leaving the battery undercharged or overcharged. The heat also cooks the connector between the stator and the regulator. When the regulator fails, it can overload the stator windings and burn them out. A common pattern is a repeat stator failure soon after the regulator is replaced. This happens when the real causes are left alone: corroded or overheated connectors and the heat-prone shunt design. Typical signs are a flat battery, dimming lights, a battery warning, or the bike dying while riding.
- Starter sprag clutch failure The starter sprag clutch (one-way clutch between starter motor and crank) can fail, particularly when battery voltage is marginal at start. Symptoms: clicking sound on start, starter spins without engaging, can strip starter motor shaft teeth and contaminate the starter cover with metal shavings. Early 1050 examples reportedly used a smaller sprag than later units; later runs are less affected but pattern persists.
- Cam chain tensioner premature wear The hydraulic automatic cam chain tensioner can wear prematurely. Aggressive engine braking accelerates damage. Symptoms: "cam chain slap," rattling under load at higher revs, ticking noise. Severe cases produce aluminum filings in cases. Aftermarket manual tensioners (often GSX-R-derived) are common owner remedies.
- Clunky gearbox, particularly neutral → 1st and 1st → 2nd Universally reported gearbox feel: "notoriously clunky" shifts, particularly on cold engines and low-speed shifts. Some 2012–2013 examples additionally suffered the neutral-indicator washer fault and the transmission detent-arm spring fault (both officially recalled). False neutrals also reported on 2016+ bikes when aftermarket quickshifter rods foul the shift arm, and when the front sprocket nut works loose.
- Throttle hesitation at low RPM and small throttle openings Touchy or jumpy throttle below approximately 4,000 rpm, particularly when rolling on in turns or in slow traffic. Root cause linked to ECU map switching from throttle-position-sensor (TPS) to manifold-air-pressure (MAP) at low RPM, occasionally to oxygen-sensor drift. Pre-2016 cable-throttle behaviour; 2016+ ride-by-wire is generally smoother but some reports of aggressive throttle response in 1st and 2nd gears persist.
- Premature front fork seal leaks Fork seal leaks reported at low mileages (approx. 6,000 miles (10,000 km)) and after winter storage. Some recurrences shortly after dealer reseals, with anecdotal reports of reused parts not being properly cleaned.
- Thin tank paint, mirror-stem rust, frame paint vulnerability Tank paint reported as relatively thin compared to Japanese rivals. Mirror stems develop surface rust after several years. Frame and swingarm paint vulnerable to chipping. Fork-leg corrosion and underbelly engine paint peeling reported on long-ownership and salt-belt bikes.
- Valve cover gasket weeping (left side of head) Light oil film on the left side of the cylinder head, particularly around the four "half-moon" rubber plugs at the cam ends that require RTV sealant on reassembly. Loose valve-cover bolts can contribute. Cosmetic rather than performance impact.
Griso 1200 8V
- Flat tappet/camshaft wear – pre‑2013 8V engines Early 1200 8V engines (built before mid‑2012) use flat tappets whose hardened coating can flake off, causing rapid cam lobe wear and potentially catastrophic engine failure. The issue typically appears between 9,300–25,000 mi (15,000–40,000 km). Late‑2012 onward engines received factory roller tappets and are unaffected. No recall was ever issued.
What they cost used
These prices compare an 11-year-old Speed Triple 1050 with an 11-year-old Griso 1200 8V.
- Speed Triple 1050
- about $8,000
- Griso 1200 8V
- about $6,100
At 11 years old, the Triumph Speed Triple 1050 sits around $8,000 while the Moto Guzzi Griso 1200 8V lands near $6,100. That's a $1,900 gap in the Griso's favor. These are US market estimates, not live listings.
What they share
- Gearbox
- 6-speed
- Front tire
- 120/70-17
Where the spec sheets split
| Speed Triple 1050 | Griso 1200 8V | |
|---|---|---|
| Seat height | 32.5 in (825 mm) | 31.5 in (800 mm) |
| Wet weight | 467 lb (212 kg) | 500 lb (227 kg) |
| Speed Triple 1050 | Griso 1200 8V | |
|---|---|---|
| Displacement | 1050 cc | 1151 cc |
| Engine | Inline-three | 90° V-twin |
| Cooling | Liquid-cooled | Air/oil-cooled |
| Power | 136 hp (102 kW) | 110 hp (81 kW) |
| Torque | 83 lb-ft (112 Nm) | 80 lb-ft (108 Nm) |
| Speed Triple 1050 | Griso 1200 8V | |
|---|---|---|
| Fuel capacity | 4.6 US gal (17.5 L) | 4.4 US gal (16.5 L) |
| Speed Triple 1050 | Griso 1200 8V | |
|---|---|---|
| Final drive | Chain | Shaft |
| Fork | Upside-down (USD) | Telescopic |
| Rear tire | 190/55-17 | 180/55-17 |
| Wheelbase | 56.5 in (1435 mm) | 60.8 in (1544 mm) |
What comes fitted, what costs extra
| Speed Triple 1050 | Griso 1200 8V | |
|---|---|---|
| Traction Control | Standard (from 2016) | Not offered |
| Ride Modes | Standard (from 2016) | Not offered |
Head to head, area by area
Both bikes on the same scale, one area at a time.